Yamabiko ECHO Robotics Turfmow 1000 Technician Manual page 119

Existing stations
If stations have already been defined a list of them is presented.
For stations associated with a positioning beacon, selecting the station enables you to
view the
enters and leaves the station.
For stations that do not contain a positioning beacon, selecting a station enables you to
view and edit the properties of the station. These are the same as those used in
the station
Start discovery
Starts a search for stations in the locality. This only applies if the stations have a
positioning beacon.
When the process is complete, a list of known stations is presented.
Create new station
Allows you to manually
This procedure is required to define a station that does not use a positioning beacon.
8.4.2.3.1 Create new station
For an installation that does not use a positioning beacon, the charging station must be
defined manually. The following parameters must be defined.
Charge
This parameters defines whether the station is used to charge the robot or not.
Connected to parcels
This defines which of the defined parcels the station is connected to. For a multi-field
installation a list of defined parcels will be presented and button next to the required one
must be checked ON.
Station Inside Parcel's Wire
This specifies whether the station is located inside or outside of the peripheral wire loop.
If the station is inside the loop, check the button ON.
Delete
Allows you to remove the manually created station from the installation.
8.4.2.3.2 Station properties
Note: The station properties listed here refer only to those stations that are associated
with a positioning beacon.
Station properties include details of a station and the positioning beacon. This menu also
allows you to specify Access parameters, which determine how the robot will enter and
leave the station, and Start Zones, which are the points at which the robot start mowing after
leaving the station.
Serial number
The serial number of the station. This will be retrieved as part of the search for the station.
Turfmow 1000 Technician's Manual
properties of the station
(page 119).
create a new station
Note: This parameter must be defined for a multi-field installation.
Version: Release 3.5
(page 119) and to configure the way that the robot
(page 119).
Chapter 8 Using your robot
creating
Last updated: 2018-12-20 119