Table of Contents
Advertisement
To change the positioning beacon board
1.
Disconnect the power cable from the positioning board. Gently press the locking guard,
then pull the cable out of the socket.
2.
Remove the three plastic braces by gently pressing them with your fingers and
unscrewing the socket cap hex screw (3mm, nut 7mm).
3.
Remove the board from the mounting bracket.
4.
Position the new board in front of the braces.
5.
Push gently until it clicks.
6.
Screw the hex nut.
7.
Re-connect the power cable of the positioning board into its socket by gently pushing it
until it clicks.
8.
Replace the station cover.
9.
Configure the settings. (Use the
Stations
Upgrade the positioning board supports
Initially the beacon positioning board was mounted in the station with a set of plastic supports.
It is recommended that one of the supports is a metal connector with an electrical connection
to ground. This is shown below and consists of the following components.
Turfmow 1000 Technician's Manual
.)
Version: Release 3.5
technician's menu
(page 114)
Chapter 7 Installation
>
Infrastructure
Last updated: 2018-12-20
69
Advertisement
Table of Contents
