Chapter 8 Using your robot
System locking
This command enables you to block the use of the robot. This is useful if the field area is in
use during the time when the robot is scheduled to be mowing. The robot will remain inactive
until the system is unblocked.
Note: It is also possible to
before specific commands can be issued.
To lock the system
1.
Press
2.
Press the up
3.
Highlight
The following screen will appear and you will need to enter the robot's pin code in order to
access the menus again.
To unlock the system
1.
Enter the 4-digit PIN code.
2.
Press
The robot will then wait for a new command to be issued.
8.3.3.1 LCD settings
To modify the LCD settings
1.
Press
106
Turfmow 1000 Technician's Manual
enable a PIN code
.
and down
arrows to highlight
then press
.
OK
.
for a few seconds.
(page 112) which must be entered
System locking
Version: Release 3.5
then press
.
Last updated: 2018-12-20