7.
Replace the cable
Rear wheels
1.
Undo the screw.
2.
Remove the wheel.
3.
Undo the 6 screws that hold the rear plate in place.
4.
Remove the cables. The upper one is the power, the lower one is the control.
5.
Undo the nuts on the motor housing.
There are two on the top, two on the side and two on the bottom.
Turfmow 1000 Technician's Manual
(page 189) if damaged.
Note: Make sure to only undo the screws shown below.
Version: Release 3.5
Chapter 11 Service and Maintenance
Last updated: 2018-12-20
181