General Parameters - Carl Valentin DYNACODE II IP53 Operating Manual

Function Menu
Ignore empty lines
Set print offset to
minimum
Ribbon saving mode
SHIFT
Max. print speed
80
In the default operation, the printing system stops for the entire layout
length until a new layout can be printed, even if the layout is mainly
empty. As some label programs do not provide any layout length,
issues may occur in connection with the number of cycles, as the
layout length remains constant despite varying lengths of the range to
be printed. With this option, all empty lines can be ignored in the
beginning, at the end or both.
Quick selection to set the print offset to the smallest possible value.
On: The print offset value is reset to the smallest possible value.
Off: The value remains at the preset print offset value.

10.11.4 General Parameters

Layout data can be printed several times laterally displaced. A
maximum utilization of transfer ribbon can be achieved.
Determination of max. print speed.
On the base of this value all necessary calculations e.g. feedback
distance and smallest possible print offset are being calculated.
Operating Manual
Dynacode II IP
03.21