Decommissioning And Dismantling - Carl Valentin DYNACODE II IP53 Operating Manual

Dynacode II IP
03.21
NOTICE!
With the open printing unit (due to construction) the requirements
of EN 62368-1 regarding fire protection casing are not fulfilled.
These must be ensured by the installation into the end device.
The print unit and parts of it (e.g. motor, printhead) can get hot during
printing. Do not touch the printhead during operation. Cool down the
print unit before changing material, removal or adjustment.
Never use highly inflammable consumables.
Carry out only the actions described in these operating instructions.
Any work beyond this may only be performed by the manufacturer or
upon agreement with the manufacturer.
Unauthorized interference with electronic modules or their software
can cause malfunctions.
Other unauthorized work or modifications to the direct print module
can endanger operational safety.
There are warning stickers on the direct print modules that draw your
attention to dangers. Therefore the warning stickers are not to be
removed as then you and others cannot be aware of dangers and may
be injured.

1.4 Decommissioning and Dismantling

NOTICE!
The decommissioning of printing system can only be carried out
by trained staff.
CAUTION!
Danger of injury by imprudent handling when lifting or placing
the printing system.

Do not underestimate the weight of the printing system
(9 ... 12 kg).

Protect the printing system against uncontrolled
movement.
Operating Manual
Introduction
9