Carl Valentin DYNACODE II IP53 Operating Manual page 140

Error Correction
Error message
14 Field number
15 Length mask
16 Unknown mask
17 Missing ETB
18 Invalid character
19 Invalid statement
20 Invalid check digit
21 Invalid SC code
22 Invalid number of
digits
23 Type check digit
24 Invalid extension
25 Offset sign
26 Offset value
27 Printhead
temperature
28 Cutter error
29 Invalid parameter
140
Cause
Received line number is invalid.
Invalid length of received mask
statement.
Transferred mask statement is
invalid.
No end of data found.
One res. several characters of
the bar code is res. are not
valid.
Unknown transferred data
record.
For check digit control the
entered res. received check
digit is wrong.
Selected SC factor is invalid for
EAN res. UPC.
Entered digits for EAN res.
UPC are invalid
< 12; > 13.
Selected check digit calculation
is not available in the bar code.
Selected zoom factor is not
available.
Entered sign is not available.
Entered offset value is invalid.
Printhead temperature is too
high.
Defective printhead sensing
device.
With cut an error occurred.
Paper jam.
Entered data do not correspond
to the characters allowed from
the application identifier.
Operating Manual
Dynacode II IP
Remedy
Check sent data.
Check connection PC - printer.
Check sent data.
Check connection PC - printer.
Check sent data.
Check connection PC - printer.
Check sent data.
Check connection PC - printer.
Change bar code data.
Change font.
Check sent data.
Check connection PC - printer.
Calculate check digit anew.
Check code data.
Check SC factor.
Check number of digits.
Check calculation of check
digit.
Check bar code type.
Check zoom factor.
Check offset value.
Check offset value.
Reduce contrast.
Change printhead.
Check label run.
Check cutter run.
Check code data.
03.21