Carl Valentin DYNACODE II IP53 Operating Manual page 83

Dynacode II IP
Printhead valve
react time
Field ribbon saving
mode
Ribbon saving priority
Save start signal
Ignore empty lines
Set print offset to
minimum
03.21
It is calculated when the printhead upwards movement is started.
Off: Field ribbon saving mode Off.
PHOnly: Only the printhead is moved. The transfer ribbon is not
stopped.
Normal: Field ribbon saving is executed only if the transfer ribbon
motor is completely stopped.
Strong: Field ribbon saving is executed, even if the transfer ribbon
motor is not stopped.
If the measured speed fluctuation of the material exceeds the
processing capability of the printing system, either the optimisation
may be reduced, or the print position shifted.
The "SaveStrt" optimisation mode already exists. If a start signal is
active during an active print, the transfer ribbon transport is controlled
in such a way that the next layout is printed directly after completion of
offset travel of the last start signal. To achieve this, however, an
optimisation with transfer ribbon retraction is not possible.
To enable a start signal during printing with retraction, this option can
be enabled. In this case, however, sufficient print offset for transfer
ribbon retraction must be ensured.
In the default operation, the printing system stops for the entire layout
length until a new layout can be printed, even if the layout is mainly
empty. As some label programs do not provide any layout length,
issues may occur in connection with the number of cycles, as the
layout length remains constant despite varying lengths of the range to
be printed. With this option, all empty lines can be ignored in the
beginning, at the end or both.
Quick selection to set the print offset to the smallest possible value.
On: The print offset value is reset to the smallest possible value.
Off: The value remains at the preset print offset value.
Operating Manual
Function Menu
83