I/O Parameters; I/O Port Parameter 1-8; I/O Port Parameter 9-16; General Parameters - Carl Valentin DYNACODE II IP53 Operating Manual

Function Menu
I/O profil
Debounce
Start signal delay
68

10.8 I/O Parameters

10.8.1 I/O Port Parameter 1-8

Input print start
Input reset error
Input reset counter
Input external print release (default: disabled)
Disabled
Disabled
Disabled
Disabled

10.8.2 I/O Port Parameter 9-16

Output error
Output print order active
Output generation
Output printing
Output ready
Output error
Output backfeed
Output ribbon prior warning

10.8.3 General Parameters

Selection of the available confiruration Std_Direct (factory setting),
Std_Direct2, StdFileSelDirect, SP_Direct0 or Old_Direct0.
The corresponding assignment is indicated in chapter 6.1, page 23.
Indication of debounce time of the dispenser input. The setting range
of the debounce time is between 0 and 100 ms.
In case the start signal is not clear then you can debounce the input
by means of this menu item.
Indication in time per second of the delay for the start signal.
Value range: 0.00 ... 9.99.
Operating Manual
Dynacode II IP
03.21