Carl Valentin DYNACODE II IP53 Operating Manual page 69

Dynacode II IP
Save signal
(intermittent mode
only)
Not ready: error
03.21
On: The start signal for the next layout can already be released during
printing the current layout. The signal is registered from the printing
system. The printing system starts printing the next layout immediately
after finishing the current one. Therefore time can be saved and
performance be increased.
Off: The start signal for the next layout can only be released if the
current layout is printed to the end and the printing system is again in
'waiting' state (output 'ready' set). If the start signal was released
already before, so this is ignored.
On: If a print order is active but the direct print module is not ready to
process the order (e.g. if it is already in 'printing' mode), then an error
message appears.
Off: No error message appears.
Speed only: If the print speed falls below the minimum, an error
message is displayed.
Operating Manual
Function Menu
69