Table Of Contents - Carl Valentin DYNACODE II IP53 Operating Manual

Dynacode II IP
03.21

Table of Contents

1 Introduction .................................................................... 7
1.1 General Instructions ....................................................... 7
1.2 Intended Use ................................................................. 7
1.3 Safety Instructions ......................................................... 8
1.4 Decommissioning and Dismantling ................................. 9
2 Machine Overview ........................................................ 11
2.1 Connection Side of Print Mechanics ............................. 11
2.2 Connector Assignment of Control Unit .......................... 12
3 Continuous Mode ......................................................... 13
3.1 Material Speed............................................................. 13
3.2 Print Principle .............................................................. 13
3.3 Material Guiding ........................................................... 14
4 Intermittent Mode ......................................................... 15
4.1 Print Principle .............................................................. 15
4.2 Print Position ............................................................... 15
5 Operating Conditions................................................... 17
6 Technical Data .............................................................. 21
6.1 Control Inputs and Control Outputs .............................. 23
6.2 Registered Functions/Profiles for Inputs/Outputs .......... 27
7 Installation and Initial Operation ................................. 33
7.1 Install the Print Mechanics at Machines ........................ 34
7.2 Required Space for Cable Outgoing ............................. 35
7.3 Connect the Pneumatic Power Supply ......................... 36
7.4 Install the protective cover for control unit IP65 ............ 37
7.5 Adjust the Pressure Power ........................................... 40
7.6 Connect the Direct Print Module ................................... 41
7.7 Before Initial Operation ................................................ 41
7.8 Print Control................................................................. 42
7.9 Initial Operation............................................................ 42
8 Load Transfer Ribbon Cassette .................................. 43
8.1 Transfer Ribbon with Coating Outside .......................... 43
8.2 Transfer Ribbon with Coating Inside ............................. 44
8.3 Increase the Clamping Force for Ribbon Roll ............... 45
9 Water and Dust Protection Unit .................................. 47
9.1 Transfer Ribbon Cassette / Cleaning Cassette ............. 47
9.2 Use the Cleaning Cassette........................................... 48
10 Function Menu ............................................................. 49
10.1 Menu Structure (Continuous Mode) .............................. 49
10.2 Menu Structure (Intermittent Mode) .............................. 54
10.3 Print Settings ............................................................... 59
10.4 Machine Parameters (Continuous Mode) ..................... 60
10.5 Machine Parameters (Intermittent Mode)...................... 62
10.6 Layout Settings ............................................................ 64
Operating Manual
Table of Contents
3