Carl Valentin DYNACODE II IP53 Operating Manual page 147

Dynacode II IP
Error message
123 Print asynchronous
124 Speed too low
125 DMA buffer
126 UID conflict
127 Module not found
128 No release signal
129 Wrong firmware
130 Language missing
131 Wrong material
132 Invalid mark-up tag
133 Script not found
134 Script failure
03.21
Cause
The label photocell does not
work in the order as it is
expected according to print
data.
The settings of the photocell
are not correct.
Settings of label size and gap
size are not correct.
No label found at the rear
printhead.
Soiled label photocell.
Labels not inserted correctly.
The print speed is too slow.
Communication problem HMI.
Configuration RFID
programming faulty.
RFID module not available.
No print release by higher-level
control (customer machine).
Firmware does not match the
used printer type.
Language file for the set printer
language is not available.
Label material does not fit to
printing data.
Invalid mark-up formatting
characters in text.
LUA script file not found.
LUA script is incorrect.
Operating Manual
Error Correction
Remedy
Check label size and gap size.
Check label photocell settings.
Check correct loading of label
material.
Insert new label roll.
Clean the label photocell.
Check if labels are inserted
correctly.
Increase the speed of
customers' machine.
Restart the printer.
Run RFID initialising.
Check the RFID module
connection.
Please contact your
responsible distributor.
Activate release signal at the
higher-level control.
Use firmware that fits to the
printer type.
Please contact your
responsible distributor.
Please contact your
responsible distributor.
User label material with
suitable label and/or gap
length.
Correct the formatting
characters in the text.
Check the file name.
Check the script.
147