Print Settings - Carl Valentin DYNACODE II IP53 Operating Manual

Dynacode II IP
Speed
(intermittent
mode only)
Contrast
Ribbon control
X displacement
03.21

10.3 Print Settings

Indication of print speed in mm/s (see Technical Data, page 21). The
print speed can be determined for each print order anew.
The setting of print speed affects also the test prints.
Value range: 50 ... 600 mm/s
Step size: 10 mm/s
Indication of value to set the print intensity when using different
materials, print speeds or printing contents.
Value range: 10 % ... 200 %.
Step size: 10 %
Examination if the transfer ribbon roll is empty and/or if the ribbon was
torn at the unwinding roll. The current print order is interrupted and an
Error Message appears at the printer display.
Off: The ribbon control is deselected, i.e. the printer continues without
an error message.
On, weak sensibility (default): The printer reacts at approx. 1/3
more slowly to the end of the transfer ribbon.
On, strong sensibility: The printer reacts immediately to the end of
the transfer ribbon.
Displacement of the complete print transverse to the paper direction.
The displacement is possible only up to the edges of the printing zone
and is determined by the width of the focal line in printhead.
Value range: −90.0 ... +90.0.
Operating Manual
Function Menu
59