Carl Valentin DYNACODE II IP53 Operating Manual page 150

Additional Information
Start print order
Refresh variable
counter
150
In case at switching off the direct print module a print order was
active, then a print start is released automatically and the required res.
actual number of printed layouts is refreshed. In case the print order
was stopped at switching off the direct print module, it is again set to
the stopped mode after switching on the direct print module anew. In
case a customized entry was active during switching off the direct
print module, the window for the first customized variable is displayed.
As in the intended file only the start values of the counter are saved,
they are refreshed at a new start of the print order by means of the
number of printed layouts. Each counter is counted corresponding
from its start value. Afterwards the position of the current and the next
counter update are correctly set by means of the update intervals.
NOTICE
Make sure that in case graphics are onto the layout they have
to be saved onto CF card.
Operating Manual
Dynacode II IP
03.21