Transfer Ribbon With Coating Inside - Carl Valentin DYNACODE II IP53 Operating Manual

Load Transfer Ribbon Cassette
Figure 19
44

8.2 Transfer Ribbon with Coating Inside

1. Turn the lever (A) 90° in clockwise direction.
2. Remove the ribbon cassette from the print mechanics
by pulling handle (B).
3. Load a new ribbon roll as far as it will go onto the
unwinding roll (C).
4. Load an empty cardboard roll as far as it will go onto
the rewinding unit (D).
5. Insert the ribbon according to illustration.
6. Fix the ribbon with an adhesive tape at the empty roll
and tighten it by some turns of the core.
7. Push the ribbon cassette again onto print mechanics
and take care that the ribbon not rips.
8. Turn the lever (A) 90° anticlockwise.
NOTICE!
The above illustration shows a left-hand printing
system. If you are using a right-hand system, then
the new roll is to be inserted at the left and the
cardboard core is to be inserted at the right side.
CAUTION!
Impact of static material on people!

Use antistatic transfer ribbon, because static discharge
can occur when removing.
Operating Manual
Dynacode II IP
03.21