Led Indicator For Communication Status - Mitsubishi Electric FR-E700 Instruction Manual

Wiring
● Handling of the Ethernet cable
– Do not touch the conductors of the cable or the connector on the inverter. Keep the conduc-
tors free of dust or dirt. Handling the conductors with oily hands or dust/dirt adhesion to the
conductors may cause transmission losses and impair normal data link operation.
– Check the Ethernet cable for the following points before use.
● The cable is not broken.
● The cable does not have a short circuit.
● The connector is properly installed.
– Do not use an Ethernet cable with a broken latch. Doing so may cause the cable to come off
or malfunction.
– Do not connect the Ethernet cable to the PU connector. The product could be damaged due
to differences in electrical specifications.
– The maximum distance between stations is specified as 100 m. However, the maximum
distance may be shorter depending on the environment. For details of the cable, contact your
cable manufacturer.
● Connecting and disconnecting of the Ethernet cable
Hold the cable connector when connecting and disconnecting the Ethernet cable. Pulling a cable
connected to the inverter may damage the inverter or cable, or result in malfunction due to poor
contact.
● Network configuration
Check the network configuration before wiring, and perform correct wiring.
3.7.3

LED indicator for communication status

Check the LED indicator for communication status to confirm the Ethernet communication status.
Fig. 3-27: LED indicator for Ethernet communication
LED indicator
SD/RD (LED indicator for communication status)
Tab. 3-19: Description of the LEDs SD/RD
FR-E700 SC EC/ENE
System configuration for Ethernet communication (FR-E700 SC ENE)
SD/RD
Description
ON (green): Transmitting/receiving data via Ethernet
FR-E700SC-ENE LED indicator communication
3 - 35