Control circuit specifications
Insert the wire into a socket.
When using a single wire or a stranded wire without a bar terminal, push an open/close button
all the way down with a flathead screw driver, and insert the wire.
CAUTION:
E
● When using a stranded wire without a bar terminal, twist enough to avoid short circuit with
a nearby terminals or wires.
● During wiring, pulling out the wire forcefully without pushing the open/close button all the
way down may damage the terminal block.
● Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips,
it may cause to damage of inverter or injury.
3 - 20
Fig. 3-11:
Cable connection
Fig. 3-12:
Open/close button
Connection of a stranded wire
Flathead screwdriver
Wiring
I001986E
I001987E