Mitsubishi Electric FR-E700 Instruction Manual page 521

Parameter
Setting the operation mode
The following explains a program to write various data to the inverter.
The following explains a program to change the operation mode of station 1 inverter to network
operation.
● Operation mode write code: HFB (hexadecimal)
● Network operation set data: H0000 (hexadecimal) (Refer to page 6-361)
● The reply code (RWr2) at the time of instruction code execution is set to D2.
(For information about the reply code (RWr2) refer to page 6-360.)
SM1536 SD1536.0 SD1540.0
(0)
M0 X20
(4)
M300
(8)
M301 X100F
10)
M302 X100F
19)
25)
Abb. 6-178: Program example 2
FR-E700 SC EC/ENE
M0
Check the data link status of the station 1
PLS M300
SET M301
MOV H0FB W102
Write operation mode write code (HFB) to
RWw2 and set data (H0000) to RWw3.
MOV H0 W103
Turn on the instruction code execution request
SET Y100F
(RY0F)
RST M301
SET M302
Read reply code (RWr2) to D2 when the instruction
code execution completion (RX0F) turns on.
MOV W2 D2
Turn off the instruction code execution request
RST Y100F
(RY0F)
RST M302
END
CC-Link IE Field Network Basic
I003130E
6 - 367