Mitsubishi Electric FR-E700 Instruction Manual page 381

Parameter
Communication Operation Command
Operation
Source (Pr. 338)
Location
Communication Speed Command
Selection
Source (Pr. 339)
Output stop
PU operation interlock
24 MRS
25 STOP Start self-holding selection
60 STF Forward rotation command
61 STR Reverse rotation command
62 RES Reset
65 X65 PU-NET operation switchover
External-NET operation
66 X66
switchover
67 X67 Command source switchover
Tab. 6-64: Writing operation and speed commands (2)
Explanation of table:
External:
NET:
Combined:
—:
NOTES The control source of communication is as set in Pr. 550 and Pr. 551.
The Pr. 338 and Pr. 339 settings can be changed while the inverter is running when Pr. 77 = "2".
Note that the setting change is reflected after the inverter has stopped. Until the inverter has
stopped, communication operation command source and communication speed command
source before the setting change are valid.
FR-E700 SC EC/ENE
0: NET
1:
0: NET
External
Combined
—
NET
NET
Operation is valid only from external terminal signal.
Control only from communication is valid.
Operation is valid from either of external terminal and communication.
Operation is invalid from either of external terminal and communication.
Selection of operation mode and operation location
1: External
2: 1:
External 0: NET
External
External
External
External
External
External
External
External
External
External
Remarks
2:
External
Pr. 79 7
Pr. 79 = 7
(When X12 signal is
not assigned)
6 - 227