Easy Operation Mode Setting (Easy Setting Mode) - Mitsubishi Electric FR-E700 Instruction Manual

Operation
4.3.3

Easy operation mode setting (easy setting mode)

A frequency inverter can be controlled alone via the control unit, through external signals (switch, SPC
outputs, external setpoint sources, etc.) or through a combination of external signals and inputs to
the control unit. The choice of operation mode is done by setting parameter 79. (Refer to section
5.1.6.)
Setting of Pr. 79 "Operation mode selection" according to combination of the start command and
speed command can be easily made.
In the following example the parameter is set to the value "3" so that the motor is started by signals
to the STF and STR terminals and the speed can be adjusted using the digital dial on the operator
device.
Screen at powering ON
The monitor display appears.
Press PU/EXT and MODE for 0.5 s.
Turn the digital dial, until "3" appears.
(Refer to the table on the next page for
other settings.)
Press SET to set.
Fig. 4-8:
NOTES If MODE is pressed before pressing SET, the easy setting mode is terminated and the display goes
back to the monitor display.
If the easy setting mode is terminated while Pr. 79 = "0" (initial setting), the operation mode
switches between the PU operation mode and the External operation mode. Check the operation
mode.
Reset can be made with STOP/RESET.
FR-E700 SC EC/ENE
Operation
One can immediately change parameter 79 by simultaneously pressing the PU/EXT
and MODE buttons.
Operation panel
Display
Flickering
Flickering
Flickering
Flicker ... Parameter setting complete!
The monitor display appears after 3s.
I001737E, I001738E
4 - 11