Connecting To The Network; Led Status Indicator; Installing Meau0865.Gsd - Mitsubishi Electric FR-A5NP Instruction Manual

2.3 Connecting To The Network

(1) Make sure the inverter is at rest with power off and the option unit is
mounted in the inverter. Connect the PROFIBUS cable created in
section 2.2 to the network.
(2) It is now safe to apply power to the inverter and run it in PU, external,
or net mode, provided that any external inverter control cables in
addition to the PROFIBUS network cable are installed correctly.

2.4 LED Status Indicator

After connecting the option unit to an active network, note the condition of
the Operating Status Indicator LED. After power-up or reset, the LED can
assume the following states:

2.5 Installing MEAU0865.GSD

Green
Module Is Not Powered Or Module Has Not Completed Power-
Off up Sequence Or Module Is NOT In Data Exchange Mode Or
Network Connectivity Is Time-out.
On Module Is Operating Normally, Ready In Data Exchange Mode.
All setup, management, or configuration software programs for PROFIBUS-
DP require the use of a Device Data Base (GSD) file MEAU0865.GSD,
please install MEAU0865.GSD properly before using any of the setup,
management, or configuration software programs.
Refer to page 37 for more details.
State Of System
9
INSTALLATION