Thermo Scientific Applied Biosystems QuantStudio 6 Pro User Manual page 111

Prepare an RNase P TaqMan
For detailed instructions to prepare a TaqMan
preparation of a TaqMan
IMPORTANT! Wear powder-free gloves while preparing the array card.
1. Remove the ViiA
room temperature (for approximately 15 minutes).
IMPORTANT! You must fill and run the RNase P array card within 60 minutes of thawing the kit.
2. Remove an array card from its box and place it on a clean, dry surface.
3. Using a permanent marker, mark the side of the empty array card with RNase P.
Location to mark each TaqMan
1
QuantStudio ™ 6 Pro Real-Time PCR System and QuantStudio
™
Array Card
™ Array Card".
™
7 Array Card RNaseP Verification Kit from the freezer, then allow it to warm to
1
™
Array Card
Chapter 7 Calibrate and verify instrument performance
Perform verification using RNase P with a TaqMan
™
Array Card, see Appendix C, "Detailed procedures for
™ 7 Pro Real-Time PCR System User Guide
7
™ Array Card
111