Set Up Or Remove The Auto Delta Feature - Thermo Scientific Applied Biosystems QuantStudio 6 Pro User Manual

Set up or remove the Auto Delta feature

Note: The Auto Delta feature is only available in the PCR stage.
1. In the Method tab, tap Edit4Advanced4VeriFlex
Note: Use
2. Tap
(Edit) in one of the PCR stages.
3. Tap Auto Delta settings.
See Figure 8
4. Enter the starting cycle to apply Auto Delta settings.
5. Set the Delta temperature slider to the
value for the difference in the temperature.
6. Set the Delta time slider to the
the difference in the time.
7. Tap Done.
A PCR step with an Auto Delta setting applied to it is denoted with an
8. In the Method tab, tap
Note: The Auto Delta setting is removed from the Method tab.
Indicates that this is the Method tab where Auto Delta settings can be removed.
1
Indicates that Auto Delta is assigned. Tap to remove the Auto Delta settings.
2
QuantStudio ™ 6 Pro Real-Time PCR System and QuantStudio
or to navigate through the method if it is not all displayed.
on page 60.
position or the
4Remove4Done to remove the Auto Delta setting.
Chapter 4 Edit a plate before starting a run
Options to edit the method of a plate file
™ Zones / Auto Delta.
position or the position, then enter the numerical
position, then enter the numerical value for
1
2
™ 7 Pro Real-Time PCR System User Guide
4
.
61