Installing The X330-20Gtx Switch; Figure 39: Attaching The Handles To The Rkmt-J13 Brackets - Allied Telesis x330-52GTX Installation Manual

Installing the x330-20GTX Switch

This section contains the procedure for installing the x330-20GTX Switch
in standard 19-inch equipment rack with the RKMT-J13 equipment rack
brackets kit. Here are the required items:
One RKMT-J13 equipment rack brackets kit.

Cross-head screwdriver (not provided).

Flat-head screwdriver (not provided).

Four standard equipment rack screws (not provided).

To install the x330-20GTX Switch in a 19-inch equipment rack, perform the
following procedure:
1. Place the switch on a table.w
2. Verify the contents of the RKMT-J13 equipment rack brackets kit.
Refer to Figure 31 on page 78 for the kit contents.
3. Attach the handles to the RKMT-J13 brackets with the four 3x6mm
screws included in the kit. Attaching the handles is optional. Refer to
Figure 39.
Figure 39. Attaching the Handles to the RKMT-J13 Brackets
4. If you want to recess the front of the switch in the equipment rack
50mm (2 in.), attach the extenders to the brackets with six of the
4x8mm screws included in the kit. Refer to Figure 40 on page 88.
x330 Series Installation Guide for Virtual Chassis Stacking
87