Installing The Plywood Base - Allied Telesis GS950 PS V2 Series Installation Manual

Chapter 5: Installing the Switch on a Wall

Installing the Plywood Base

64
A plywood base is recommended when installing the switch on a wall that
has wooden studs, with the standard brackets. Consult a qualified building
contractor for installation instructions for the base. The installation
guidelines are listed here:
 The recommendations dimensions of the base are provided in
"Plywood Base for a Wall with Wooden Studs" on page 61.

Use a stud finder to identify the middle of studs and hot electrical
wiring in the wall.
 Attach the base to two wall studs with a minimum of four screws.
 The selected wall location for the base should adhere to the
recommendations in "Choosing a Site for the Switch" on page 46
and "Recommended Minimum Reserved Wall Area" on page 59.