Table of Contents
Advertisement
Chapter 14: Installation
To install software on an HP 9000 system
To install software on an HP 9000 system
Required Hardware and Software
To install and use the debugger's graphical interface, you need:
•
•
•
514
HP 9000 Series 300/400 computer running HP-UX version 8.01 or later,
or HP 9000 Series 700 computer running HP-UX version 8.01 or later.
To check the HP-UX operating system version, enter the uname -a
command at the HP-UX prompt. If the version number of the HP-UX
operating system is less than 8.01, you must update the operating system
to version 8.01 or higher before you can use the debugger. (Refer to the
"Updating HP-UX" chapter of the HP-UX System Administration Tasks
manual for detailed information concerning updating your system.)
Motif/OSF. For HP 9000 Series 700 workstations, you must also have the
Motif 1.1 dynamic link libraries installed. They are installed by default, so
you do not have to install them specifically for this product, but you
should consult your HP-UX documentation for confirmation and more
information.
Hardware and Memory. The debugger's graphical interface requires
workstations to have a minimum of 16 megabytes of memory. Series 300
workstations should have a minimum performance equivalent to that of a
HP 9000/350. A color display is also highly recommended.
Approximately 16 Mbytes of disk space.
HP B1466 debugger/simulator software.
Advertisement
Table of Contents
