YASKAWA MP2000 Series User Manual page 32

2.3 Mounting/Removing SVA-01 Modules
2.3.1 Mounting a SVA-01 Module
( 3 ) Mounting SVA-01 Modules
1.
Insert a SVA-01 Module.
Guide rails can be seen or are located at the top and bottom of the optional module mounting slot, as shown in the
following diagram. While holding both the top and bottom of the Module, line up the Module with the guide rails
inside the option slot, make sure the Module is straight and insert it.
 If the Module is not lined up with the guide rails, the FG bar on the bottom inside the slot may become dam-
aged.
2.
Mount onto the mounting base.
After the SVA-01 Module has been completely inserted, firmly push the front of the Module into the mounting-
base connectors. If the SVA-01 Module has been installed correctly, the front of the SVA-01 Module and the
hook will be aligned.
3.
Mount the panel of the SVA-01 Module.
Line up the notch on the bottom of the panel with the tab on the bottom of the Machine Controller.
This completes the installation procedure.
2-6
Guide
rail