YASKAWA MP2000 Series User Manual page 264

8.1 Switchable Motion Commands
8.1.12 Switching from PHASE
Switched From
PHASE
8-38
Switched To
The axis will decelerate to a stop in speed control mode, and the control mode will be
changed from speed control mode to position control mode when the axis stops.
PHASE will switch to INTERPOLATE when the axis stops after deceleration.
INTERPOLATE
<Change in Position Reference Setting (OL1C) during Deceleration>
• In Incremental Addition Mode (OW09, bit 5 = 0)
Any change in the Position Reference Setting (OL1C) will be ignored.
• In Absolute Mode (OW09, bit 5 = 1)
The change in the Position Reference Setting (OL1C) will be output as soon as the
first high-speed scan after INTERPOLATE execution starts.
 Do not change the Position Reference Setting during deceleration unless it is
absolutely necessary.
ENDOF_INTER
Same as INTERPOLATE
POLATE
LATCH Same as INTERPOLATE
PHASE will immediately switch to FEED, and the control mode will be changed from
phase control mode to position control mode.
 FEED switched from PHASE starts its operation with the empty accel/decel
filter. Therefore, when the accel/decel filter is set for FEED command, the
speed will not smoothly change, and the distribution will be started from the
state Speed = 0 (see (1).) To change the speed smoothly, do not set the filter
for FEED command (see (2).)
(1) When Using the Accel/Decel Filter for FEED Command
FEED
Operation
In speed control mode, the axis will
decelerate to a stop from the speed when
the motion command is switched.
PHASE
PHASE
Motion command
Motion command
PHASE
response
Phase control mode
Distribution will start from the state Speed = 0
since the accel/decel filter is empty.
PHASE
Motion command PHASE
Motion command
PHASE
response
Phase control mode
INTERPOLATE
INTERPOLATE
INTERPOLATE
Position control mode
Speed control mode
FEED
FEED
FEED
Position control mode