Warm Settings For "Lo 2-Stage" And "Lo 3-Stage - Siemens LMV36.520A1 Basic Documentation

28.11.11 Warm settings for «Lo 2-stage» and «Lo 3-stage»
Wait until the burner is operating and symbol ▲ or ▼ is no longer highlighted! The startup sequence
stops in phase 36 Traveling to ignition position. The ignition point can be adjusted under cold
conditions.
A
and
or
as well as
and
F A
and
or
Building Technologies Division
Infrastructure & Citiies Sector
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic documentation LMV36...
28 Parameter level
Identification of start for setting the curve
parameters.
The display shows run Oil0 or run Oil1,
depending on the type of fuel currently burnt.
%
Provided the controller is enabled!
/reset
Phase Standby (stationary)
%
Phase Fan ramp up
(fan motor = ON, safety valve = ON)
%
Phase Traveling to prepurge
%
Phase Prepurging
%
Phase Traveling to ignition
%
Ignition position P0 can be set only when
symbol ▲ or ▼ is no longer highlighted.
Keep depressed and, for VSD
A
Press or
%
When symbol ▲ or ▼ is no longer highlighted,
the next curvepoint P1 can be selected with
.
position
position
and
F A
to adjust the value.
209/248
CC1P7544en
25.09.2013
.