Setting Of Curvepoints For Multistage Mode ("Lo 2-Stage" And "Lo 3- Stage") - Siemens LMV36.520A1 Basic Documentation

28.11.10 Setting of curvepoints for multistage mode («Lo 2-stage» and «Lo 3-
stage»)
Example of «Lo 2-stage»
A
A
and
or
and
F A
and
F A
and
or

208/248
Building Technologies Division
Infrastructure & Citiies Sector
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Note
You are now given the choice of proceeding with the warm settings by pressing
(refer to chapter Warm settings for modulating mode «G mod», «Gp1 mod», «Gp2
mod» and «Lo mod»), or with the cold settings by pressing
chapter Cold settings for «G mod», «Gp1 mod», «Gp2 mod» and «Lo mod»).
Basic documentation LMV36...
28 Parameter level
P0 appears blinking.
Curvepoint for ignition load.
%
Keep depressed.
A
You are now at P0 of air actuator A.
%
Press simultaneously
adjust ignition position P0 of the air actuator.
Example: 20.0
%
Keep and
F
You are now at n0 of the VSD.
%
Press simultaneously
or to adjust speed n0 of the VSD.
Example: 20.0
%
Now, release
A
The selected value is adopted.
Example: 20.0
%
Identification of start for setting the curve
parameters.
The display shows run Oil0 or run Oil1,
depending on the type of fuel currently burnt.
%
and or to
A
depressed.
A
and and
F
A
.
/reset
ESC
(refer to
CC1P7544en
25.09.2013