Setting Curvepoints P0 And P9 For Modulating Operation ("G Mod", "Gp1 Mod", "Gp2 Mod" And "Lo Mod") - Siemens LMV36.520A1 Basic Documentation

28.11.2 Setting curvepoints P0 and P9 for modulating operation («G mod»,
«Gp1 mod», «Gp2 mod» and «Lo mod»)

Example of «G mod»
F
F
and
or
A
A
and
or
and
F A
196/248
Building Technologies Division
Infrastructure & Citiies Sector
Note
Not all actuators used in the following example can be set, depending on the
selected operating mode.
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h s min %
Basic documentation LMV36...
28 Parameter level
Display P0 appears blinking.
Curvepoint for ignition load.
%
Keep depressed.
F
You are now in setting P0 of fuel setting F for
ignition position P0.
%
Press simultaneously
set ignition position P0 of the fuel damper.
Example: 30.0
%
Release .
F
The selected value is adopted.
%
Example: 30.0
Keep depressed.
A
You are now in setting P0 of air actuator A for
ignition position P0.
%
Press simultaneously
set ignition position P0 of the air actuator.
Example: 22.0
%
Release .
A
The selected value is adopted.
%
Example: 22.0
Keep and
F
A
You are now in setting n0, speed n is for ignition
position n0
and or to
F
and or to
A
depressed.
CC1P7544en
25.09.2013