Siemens LMV36.520A1 Basic Documentation page 212

To the next curvepoint
A
and
or
as well as
and
F A
and
or
To the next curvepoint
212/248
Building Technologies Division
Infrastructure & Citiies Sector
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic documentation LMV36...
28 Parameter level
Curvepoint P2 can only be adjusted when
symbol ▲ or ▼ is no longer highlighted.
Fuel valve V2 is switched on.
Keep depressed and, for VSD
A
Press or
%
When symbol ▲ or ▼ is no longer
highlighted, the next curvepoint P2of can be
selected with .
Curvepoint P2of is now adjusted.
The system remains at P2.
Adjust the switch-off point with no travel.
Now, the point is approached dynamically
when traveling from P2 to P1.
%
When symbol ▲ or ▼ is no longer
highlighted, the next curvepoint P1 can be
selected with
Automatic mode is released when, after
reaching P1, the curve settings are quit with
ESC.
If the settings are aborted earlier (ESC or
shutdown due to fault), start prevention OFF
% UPr0 or OFF UPr1 is still active until all points
are set.
ESC
When symbol ▲ or ▼ is no longer highlighted,
ESC can be pressed a second time.
%
Back to the previous
curvepoint
and
F A
to adjust the value.
Back to the previous
curvepoint
.
Back to the previous
curvepoint
CC1P7544en
25.09.2013
.