Interpolation Of Curvepoints - Siemens LMV36.520A1 Basic Documentation

28.11.8

Interpolation of curvepoints


To the next curvepoint
F
F
and
or
A
A
and
or
To the next curvepoint
204/248
Building Technologies Division
Infrastructure & Citiies Sector
Note
Changing a curvepoint in the cold position requires a new approach to all
curvepoints in the warm position to verify the change on the burner itself. After
changing the curvepoint, the normal display of the AZL2... shows OFF UPr0 / OFF
UPr1.
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic documentation LMV36...
28 Parameter level
or
The selected curvepoint is displayed.
%
Keep depressed.
F
The fuel actuator has been selected for
changing.
%
Keep depressed and press
F
adjust the fuel actuator.
In the case of warm settings, the actuator
follows directly the adjustments made.
%
The changes are saved.
After releasing
again.
%
Keep depressed.
A
The air actuator has been selected for editing.
%
Keep depressed and press
A
adjust the air actuator.
In the case of warm settings, the actuator
follows directly the adjustments made.
%
The changes are saved.
After releasing
again.
%
to select the curvepoint
or
, the point is selected
F
or
, the point is selected
A
Back to the previous
curvepoint
CC1P7544en
25.09.2013
to
to