Temperature Sensors; Obtaining An Error Log - Christie M Series Service Manual

Temperature sensors

The following sections provide details about the temperature sensors.
Interface temperature sensors
ID Interface
2 I2C
3 I2C
4 I2C
7 RS232
8 RS232
9 Single wire
13 Single wire
14 Single wire
15 Single wire
16 Single wire
Fan temperature sensors
ID Location
2 Card cage cooling
3 Lamp 2 blower
4 Lamp house exhaust
5 Light engine intake
6 Light engine exhaust
7 Lamp driver cooling
8 Lamp 1 blower
9 Cold mirror cooling

Obtaining an error log

For the interrogator to successfully retrieve diagnostic files, the projector must remain in its failed
state while the interrogator is operating. Always run the interrogator before power cycling the
projector; otherwise, important diagnostic files become unusable.
1. Open a web browser and type the IP address of the projector into the address bar.
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Location
Projector exhaust temperature
Light Engine intake temperature
Light Engine exhaust temperature
Located in lamp driver 1 and accessed through the driver's serial
port
Located in lamp driver 2 and accessed through the driver's serial
port
Located on the panel driver and monitors the board temperature
Located on slot 1 option card and monitors option card temperature
Located on slot 2 option card and monitors option card temperature
Located on slot 3 option card and monitors option card temperature
Located on slot 4 option card and monitors option card temperature
Troubleshooting
28