Normal Power Up; Lcd Keypad And Rear Status Leds; Temperature Sensors - Christie J Series Service Manual

Section 3: Troubleshooting
3.2

Normal Power Up

3.2.1 LCD Keypad and Rear Status LEDS

The color of the keypad key indicates the state:
• Amber: functionality is available which will affect the
displayed image of the projector.
• Blue: functionality is available and relevant to the built-in
LCD only and will not affect the displayed image of the
projector.
• Off: the key is disabled in the current context.
Table 3.1 Rear Status LEDs Startup Time Chart
Time (approximate)
0 seconds
30 seconds
40 seconds
1 minute and 40 seconds
to
1 minute and 50 seconds
1 minute and 50 seconds
to
1 minute and 55 seconds
NOTE: Once the projector is in standby mode, use the down arrow on the keypad to interact with the
projector.
3.3

Temperature Sensors

Sensor ID
1 Located within the front air intake vent and monitors the projector intake temperature
3 Located on the lamp exhaust duct and monitors the projector exhaust temperature
9 Located on the panel driver and monitors the board temperature
10 Located within the card cage and monitors the image processor board temperature
13 Located on slot 1 option card and monitors option card 1 temperature
14 Located on slot 2 option card and monitors option card 2 temperature
15 Located on slot 3 option card and monitors option card 3 temperature
16 Located on slot 4 option card and monitors option card 4 temperature
3-2
Rear Status LEDs
LAMP-1 COMM
Amber Amber
Off Off
Off Off
Off Off
Off Off
Location and Purpose
STATUS SHUTTER
Amber Amber "Please Wait"
Off Off "Please Wait"
Off Off "Initializing projector"
Off Off "Initializing projector"
Amber Amber "Standby mode
J Series 1000W and 1200W Service Manual
LCD Display
Press and hold POWER
to turn on projector"
020-100725-04 Rev. 1 (07-2015)