8. To remove the interlock switch, unplug the connector for the interlock switch cable.
9. Replace the interlock switch.
10. To re-install, follow these steps in reverse order.
Removing the AC inlet
To remove the AC inlet, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board module.
See
Replacing the main board
3. Remove the main board bottom shielding.
See
Removing the rear cover
4. Remove the rear cover.
See
Removing the rear cover
5. Remove the front cover.
See
Removing the front cover
6. Remove the left-side cover.
See
Removing the left-side cover
7. Remove the four M3 screws with a Phillips #1 screwdriver securing the AC inlet module.
8. Unplug the AC inlet to the power supply connectors.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
on page 94.
on page 59.
on page 59.
on page 61.
on page 63.
Electronics
79