Removing The Ac Inlet - Christie HS 2K Series Service Manual

8. To remove the interlock switch, unplug the connector for the interlock switch cable.
9. Replace the interlock switch.
10. To re-install, follow these steps in reverse order.

Removing the AC inlet

To remove the AC inlet, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board module.
See Replacing the main board
3. Remove the main board bottom shielding.
See Removing the rear cover
4. Remove the rear cover.
See Removing the rear cover
5. Remove the front cover.
See Removing the front cover
6. Remove the left-side cover.
See Removing the left-side cover
7. Remove the four M3 screws with a Phillips #1 screwdriver securing the AC inlet module.
8. Unplug the AC inlet to the power supply connectors.
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
on page 94.
on page 59.
on page 59.
on page 61.
on page 63.
Electronics
79