7. Slide the card cage out along the guides.
To avoid possible damage, carefully place the card cage on a clean, flat surface.
8. To re-install or replace the card cage, follow these steps in reverse order.
Removing the AC breaker
The AC breaker is located at the rear of the projector.
1. Remove the rear cover (on page 33).
2. Using an 8 mm deep socket nut driver, uninstall the ground harness ends.
3. Remove the four screws.
4K40-RGB Series Service Guide–D4K40-RGB, Roadie 4K40-RGB, Mirage 4K40-RGB
020-102960-02 Rev. 1 (12-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Electronics
57