Removing The Ac Inlet And Keypad; Removing The Power Supply - Christie GS Series Service Manual

3. To separate the right cover and interlock switch, remove the two M3 screws.
4. Replace the interlock switch.
5. To re-install, follow these steps in reverse order.

Removing the AC inlet and keypad

Remove the AC inlet and keypad from the rear cover.
1. Remove the top cover.
See Removing the top cover
2. Remove the rear cover.
See Removing the rear cover
3. To separate the AC inlet from the rear cover, remove the two M3 screws.
4. To separate the keypad and the rear cover, remove the two M3 screws with a Phillips #1
screwdriver.
5. Replace the affected part.
6. To re-install, follow these steps in reverse order.

Removing the power supply

To remove the power supply, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
on page 57.
on page 58.
on page 57.
Electronics
68