Removing The Rear Top Lid; Removing The Front Lamp-Side Cover; Removing The Lamp Door - Christie Roadie 4K35 Service Manual

Removing the rear top lid

The rear top cover provides access to the low profile extractor, reflector and heat dump, and other
components.
Estimated replacement time: 5 minutes
1. Shut down the projector (on page 22).
2. Remove the front cover (on page 40).
3. Remove the four screws securing the rear top cover.
4. Remove the cover.
5. To re-install, follow these steps in reverse order.

Removing the front lamp-side cover

Estimated replacement time: 1 minutes
1. Shut down the projector (on page 22).
2. Remove the shroud, if installed (on page 40).
3. Loosen the three captive screws securing the cover.
4. Pull the cover up to clear the bottom tabs and remove.
5. To re-install, align the bottom tabs and follow these steps in reverse order.

Removing the lamp door

Remove the lamp door to access the lamp compartment.
Estimated replacement time: 1 minutes
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Parts and module replacement
42