Removing The Right-Side Cover - Christie GS Series Service Manual

2. Remove the two M3 screws.
3. Unplug the two connectors securing the LED board.
4. Loosen the six captive M3 screws securing the front cover module.
5. Loosen the four captive M3 screws securing the dust cover module.
6. Transfer the dust cover module to the new front cover.
7. Replace the front cover.
8. To re-install, follow these steps in reverse order.

Removing the right-side cover

The right side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
See Removing the top cover
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
on page 57.
Projector covers and feet
59