Removing The Right-Side Cover - Christie HS 2K Series Service Manual

See Replacing the front IR sensor boards
11. Transfer the IR sensor board to the new front cover.
12. If required, replace the front cover.
13. To re-install, follow these steps in reverse order.

Removing the right-side cover

The right-side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board module.
See Replacing the main board
3. Remove the main board bottom shielding.
See Removing the rear cover
4. Remove the front cover.
See Removing the front cover
5. Remove the rear cover.
See Removing the rear cover
6. Remove the five M3 screws with a Phillips #1 screwdriver securing the right-side cover.
7. Remove the right-side cover from the projector.
It will still be attached to the cord of the filter-R switch.
8. Remove the filter-R switch.
See Removing the filter-R switch
9. Transfer the filter-R switch to the new right-side cover.
10. If required, removing the right-side cover.
11. To re-install, follow these steps in reverse order.
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 93.
on page 59.
on page 94.
on page 59.
on page 61.
on page 59.
on page 73.
Projector covers and feet
62