Abus SECVEST Installer Manual page 313

Supervision
Jamming
Level4 updates
Tamper Omit
Force Set
Remote Unset Full Set
Remote Unset Part Set
Ctrl Device Unset Full Set
Ctrl Device Unset Part
Set
Auto Rearm
Silence Alerts
Abort time
Siren Delay (Ben)
Entry Alarm Delay
Broadcast Panel Status
Panel upgrade
Checking for an upgrade?
Backup/restore
Backing up config to the
SD card
Loading config from SD
card
Report
5. COMMUNICATION
Network
Network Setup
Web server
DHCP
IP address
IP Port Number
Internal HTTP port
Internal HTTPS port
IP Subnet Mask
Fault
Tamper when country = UK
Fault
Tamper when country = UK
Disabled
Disabled
Off
Always
Always
Always
Always
Never
User Code
120 seconds
0 minutes
Enabled
No
Enabled
On
Empty
80
80
4433
Empty
"TAMPER" for UK to fulfil
PD6662:2010
"TAMPER" for UK to fulfil
PD6662:2010
This setting is required to fulfil
EN 50131.
If Force Set is enabled, the system
is not compliant with EN 50131.
This setting is required to fulfil
EN 50131.
Only appears if the confirmation
mode is set to "Basic".
This setting is required to fulfil
EN 50131-1 8.3.8.2.
"V3.00.03 – Installed"
Once the selection has been made,
the alarm panel automatically
checks whether a new software ver-
sion is available on the ABUS FTP
server.
"Secvest—04-12-2017-0932.cfg"
Only on web interface
This option will only be displayed,
S/W>=2.00.00 DHCP=off
S/W <2.00.00
This option will only be displayed,
S/W <2.00.00 if an IP address is en-
tered.
Appendix
313