Page 1
SHSG10000 ABUS Z-Wave Siren Important information and FAQs about this product and other products can be found on the website www.abus.com Version 1.0 Original operating instructions in English. Keep for future use!
Your rights are limited to the repair or replacement of this product as delivered. ABUS Security Center assumes no liability for any special, incidental or consequential...
English 2. Important Safety Informations 2.1. Intended Use Only use the device for the purpose for which it was built and designed. Any other use is considered unintended. All guarantee claims are invalid in the event of damage caused by non- compliance with this safety information.
English The battery must not be directly exposed to heat or sunlight, and must not be stored in a place with a very high temperature. The battery must not come into contact with water. The battery must not be dismantled, pierced or otherwise damaged. The battery contacts must not be short-circuited.
UPS. Avoid overloading electrical sockets, extension cables and adapters, as this can result in fire or electric shock. 3. Product introduction 3.1. Scope of delivery ABUS Z-Wave Siren Quickguide & Safety instructions 3.2. Device features...
In case of alarm the ring lights up red Operating Principle The SHSG10000 was developed for use in home automation systems that use the Z- Wave wireless standard. The siren serves as an alarm device and is equipped with a loud siren (up to 95 dB) and a red LED flash.
English Click the + (Add) button in your Z-Wave App and follow the further instructions Press the Network-button 3 times within 1.5 seconds and the Status-LED will flash 3 times If the Add device process is successful, the Status-LED will turn off. Repeat the inclusion process from step B if it was not successful.
English Press the Network-button 3 times within 1.5 seconds and the Status-LED will flash 3 times If the Remove device process is successful, the Status-LED flash 6 times. Repeat the inclusion process from step B if it was not successful. 4.3.
English 5. Advanced Z-Wave Parameters 5.1. Association Group Information Z-Wave devices can control other devices directly. This direct control is called in Z- Wave association. For this purpose, the device ID of the device to be controlled must be stored in the controlling devices. This is done in so-called association groups. An association group is always linked to an event in the controlling device (pressing a key or triggering a sensor).
English 6. Technical Specifications Parameters Unit SHSG10000 Dimensions (Ø x D) 80 x 80 Weight 0 – 40 Operating Temperature °C Max. Humidity IP Class Radio frequency 868,42 (Z-Wave PLUS, Europe) Modulation Material Transmission power < 4,5 110 – 240 V AC...