Abus SECVEST Installer Manual page 212

Configuration
Unset Comms
Burg
Comms
Rearm
Dynamic Auto Report
Telecoms Priority
212
Enabled
The alarm system transmits all status messages to the ARC, regardless of whether
the system is armed or disarmed.
Deactivated
The alarm system transmits tamper, network failure and other status messages to
the ARC while it is armed. When disarmed, the status messages are not transmitted
to the ARC.
Only appears when "System → Confirmation → Confirmation Mode = Basic" and
"Communications → Protocol = Fast Format")
Enabled
• The alarm system activates channel 3 again as soon as the siren time has ex-
pired. After channel 3 has been reactivated, an event can be transmitted again if it
occurs. The system automatically omits triggered zones in this case.
• Note: if a "Final Door" zone is triggered, channel 3 is activated at the end of the
configured entry/exit time.
Deactivated
Channel 3 remains activated until a user or installer resets the system.
Enabled
The dynamic test call is activated.
The test call is started every 24 hours after the last transmission.
Note
The advantage of the dynamic test call is that a test transmission is only made to
the monitoring station if there was no transmission in the last 24 hours. If you have
programmed an active/disarmed transmission, then it is possible that no test trans-
mission will be made for several days if the system is activated or disarmed daily.
Deactivated
The dynamic test call is deactivated. The "Static Test Call" dropdown selection field
appears.
Set the order in which the communication methods should be used here.
• Ethernet / IP
1, 2, 3 or No
Mobile
• PSTN
1, 2, 3 or No
• GSM/mobile
1, 2, 3 or No
Note:
The alarm control panel automatically uses the IP-based protocol DC-09 if the alarm
control panel uses Ethernet (LAN) as an outgoing communication path.
In doing so, the data from traditional protocols are packed into IP packages and
transferred.
For details, see the "ARC/ESCC reporting protocols" appendix
S/W >=3.00.05
Set the order in which the communication methods should be used here.
• Ethernet / IP
1, 2, 3 or No
Mobile
Note
means data transfer according to the setting via IP gateway the "IP
Mobile Setup" menu
• PSTN
1, 2, 3 or No
• Mobile
1, 2, 3 or No