Abus SECVEST Installer Manual page 270

Configuration
Function Meaning
Voice dial- Speech Dialler must be activated.
ler
Installer Mode->Communications->Speech Dialler->Call Mode->Enabled
A list of the available connected transmission paths can be seen:
Ethernet
• Once this has been selected, enter a valid SIP User ID.
• e.g. +498207123456789@sipgate.de
• Press the "OK" button.
• The alarm panel establishes a connection. If the call is answered by this recipient, the recipient hears
the "Home Message" and "Message 1" to "Message 4".
S/W >=2.00.00
• When this is selected, the configured recipients are displayed with their contact names as stored in the
phone book.
• Scroll to the desired contact. Press the "Select" or "Start" key in the web interface.
• The alarm panel sends a test call to this recipient.
PSTN
• When this is selected, enter a number to dial.
• Press the "OK" button.
• The alarm panel establishes a connection. If the call is answered by this recipient, the recipient hears
the "Home Message" and "Message 1" to "Message 4".
S/W >=2.00.00
• When this is selected, the configured recipients are displayed with their contact names as stored in the
phone book.
• Scroll to the desired contact. Press the "Select" or "Start" key in the web interface.
• The alarm panel sends a test call to this recipient.
GSM / Mobile
• When this is selected, enter a number to dial.
• Press the "OK" button.
• The alarm panel establishes a connection. If the call is answered by this recipient, the recipient hears
the "Home Message" and "Message 1" to "Message 4".
S/W >=2.00.00
• When this is selected, the configured recipients are displayed with their contact names as stored in the
phone book.
• Scroll to the desired contact. Press the "Select" or "Start" key in the web interface.
• The alarm panel sends a test call to this recipient.
If "Call Acknowledge" is activated:
• The recipient can acknowledge and end the call with 5 or 9 respectively if the following is set: Installer
Mode->Communications->Speech Dialler->Call Acknowledge
->Enabled.
• During the test call a series of progress messages appear on the display.
If the test call was not successful, the display shows a brief message with the cause of the error.
SMS Text messages must be activated and the contact must be saved in the phone book.
Installer Mode->Communications->SMS->Call Mode->Enabled
A list of the available connected transmission paths can be seen:
PSTN
270