Extron electronics XMP 240 C AT User Manual page 13

• These products are intended for use with a UL Listed power source
marked "Class 2" or "LPS" and rated 12 VDC, minimum 1.0 A. or 48 VDC
(PoE), minimum 0.35 A, or 56 VDC (PoE), minimum 0.8 A.
•
Ces produits doivent être utilisés avec une source d'alimentation certifiée
UL de classe 2 ou LPS avec une tension nominale 12 Vcc, 1,0 A minimum,
ou 48 Vcc (PoE), 0,35 A minimum, ou 56 Vcc (PoE), 0,8 A minimum.
• The power supply shall not be permanently fixed to building structure or
similar structure.
•
La source d'alimentation ne devra pas être fixée de façon permanente à la
structure de bâtiment ou à d'autres structures similaires.
• Power over Ethernet (PoE) is intended for indoor use only. It is to be
connected only to networks or circuits that are not routed to the outside
plant or building.
•
L'alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur
uniquement. Elle doit être connectée seulement à des réseaux ou des
circuits qui ne sont pas routés au réseau ou au bâtiment extérieur.
•
The XMP is intended for connection to a Power over Ethernet circuit
for intra-building use only and are considered to be part of a Network
Environment 0 per IEC TR62101.
• Le XMP est conçu pour une connexion à un circuit PoE pour une
utilisation intérieure seulement et est considéré comme faisant partie d'un
environnement réseau 0 par IEC TR62101.
EXP Port — One RJ-45 port allows two units to be connected via a shielded CAT 6
B
cable to form a larger matrix system (1 foot cable included). Any Extron device with EXP
capability can exchange audio with a XMP 240 C AT via the EXP port.
AT Ports — Two RJ-45 ports form a Gigabit switch for use with a Dante network. The
C
AT ports use Dante protocol for digital audio transport (AT) and allow the XMP 240 C AT
to connect to a Dante audio network to form a larger matrix
page 89). The 2-port switch can be configured as one primary and one secondary
port for redundant Dante configurations. In redundant configuration, audio traffic is
duplicated. Port 1 is the primary port (PRI) and Port 2 is the secondary switch (SEC)
(see Redundant Configuration
The AT port LEDs indicate the following:
• Green only = 100 Mbps connection
• Amber only = 1 Gb connection
RS-232 Port — Use a 3-pole 3.5 mm captive screw connector to connect the host
D
RS-232 cable for bidirectional RS-232 (±5V) serial control (see figure 5 for wiring). The
default baud rate is 38400.
Connected RS-232
Device Pins
Receive
Transmit
Ground
Figure 4. RS-232 Wiring Example
(Dante Controller
on page 96).
RS-232
Tx Rx G
XMP 240 C AT • Installation
on
6