Table of Contents
Advertisement
To configure the XMP 240 C AT in redundant mode using Dante Controller:
1.
Open Dante Controller.
2.
Press <
> on the keyboard to access the
Ctrl+D
3.
Select the desired XMP 240 C AT from the
menu (see figure 132,
1
4.
Select the
Network Config
5.
From the
Dante Redundancy
Figure 132.
Redundant Mode Configuration in Dante Controller
To configure the XMP 240 C AT in redundant mode using DSP Configurator:
1.
Use DSP Configurator to connect to the XMP 240 C AT in Live mode (see
Emulate Panel
on page 17).
2.
Select
Tools > Device Settings
3.
In the
Device Settings
and select the
Dante Device
4.
Select
Enable Redundant Mode
5.
Select
or
DHCP
Static IP
6.
Click
(
).
Apply
4
Figure 133.
Redundant Mode Configuration in DSP Configurator
Device View
(Choose a Dante Device...)
).
tab (
).
2
panel, use the drop-down to select
.
dialog box, use the right navigation arrow (
tab (see figure 133,
1
(
).
2
and enter a valid redundancy network configuration (
XMP 240 C AT • Dante Controller
dialog box.
drop-down
(
).
3
Redundant
Live and
) to navigate to
).
3
).
97
Advertisement
Table of Contents
