Extron electronics XMP 240 C AT User Manual page 69

seconds of delay.
8. Click at the top of the dialog box and enter a new name for the macro in
Change Name
the text field. Default macro names are
Select Macro
9. Up to 32 actions can be configured per macro. Follow steps 3 through 7 to configure
additional actions. Right click the left-most field in an action to cut, copy, or paste
actions in a macro.
10. Connect Live to the XMP 240 C AT and click
XMP 240 C AT. Once the macro has been pushed, it can be run via DSP Configurator, a
control system, or SIS commands.
NOTES:
• A macro cannot be run until it is pushed to the device. Edits made to an existing
macro must also be pushed to the device.
• Macro configuration data is saved on a per-line basis. When an action is completely
configured, the data is saved even if the
• Macro configurations are saved when the DSP Configurator configuration file is
saved.
• If DSP Configurator is closed without saving the configuration file or pushing the
macro to a XMP 240 C AT, unsaved macro configuration data is deleted.
To delete a Macro:
1. Click
Tools > Configure Macros
2. From the
Select Macro
3. Once the macro information is displayed, click
corner of the
Configure Macros
To clone a Macro:
1. Click
Tools>Configure Macros
2. From the
Select Macro
3. Click at the bottom of the
Clone Macro
4. Use the drop-down in the
macro. By default, the next empty macro slot is selected as the destination.
NOTE: If a macro already exists in the selected destination, a warning message
appears below the drop-down, warning that the existing macro will be overwritten
with the cloned macro.
5. Click to clone the macro or
OK
6. After the macro is cloned, the new macro is displayed in the
box. The cloned macro has a default macro name.
To run a Macro:
1.
Connect to the XMP 240 C AT in Live mode (see
page 17).
2. Click
Tools > Configure Macros
3. From the
Select Macro
4. Once the macro information is displayed, click
-or-
1. Connect to the XMP 240 C AT in Live mode (see
Push Macro to Device
Configure Macros
.
drop-down, choose the macro to be deleted.
Delete Current Macro
dialog box.
.
drop-down, choose the macro to be cloned.
Configure Macros
dialog to select a destination for the cloned
Clone Macro
to cancel the action.
Cancel
Live and Emulate Panel
.
drop-down, choose the macro to be run.
Run Macro
Live and Emulate Panel
XMP 240 C AT • Configuration Tools
Macro 1 , Macro 2 , and so on.
to push it to the
dialog box is closed.
in the bottom left
dialog box.
dialog
Configure Macros
on
.
on
74