Table of Contents
Advertisement
Rear Panel Features and Cabling
l
POWER
12V
1.0A MAX
1 (PRI) PoE
2 (SEC)
A
B
C
C
Power Input
A
EXP Port
B
AT Ports
C
Figure 2.
XMP 240 C AT Rear Panel
Power Input — Connect the included external 2-pole captive screw power supply (see
A
the figure below for power supply wiring information).
NOTE: If a power supply is not provided, use a UL Listed power supply with rated
output 12 VDC, minimum 1.5 A, and marked "Class 2" or "LPS".
POWER
12V
2.0A MAX
Rear Panel
Power Receptacle
DC Power Cord
Captive Screw
Connector
3/16"
Ground all
(5 mm) Max.
Devices
G
Ground
+12 VDC input
Figure 3.
Power Input Wiring
ATTENTION:
•
Always use a power supply provided by or specified by Extron. Use of an
unauthorized power supply voids all regulatory compliance certification
and may cause damage to the supply and the end product.
•
Utilisez toujours une source d'alimentation fournie ou recommandée par
Extron. L'utilisation d'une source d'alimentation non autorisée annule toute
certification de conformité réglementaire, et peut endommager la source
d'alimentation et l'unité.
•
The installation must always be in accordance with the applicable
provisions of National Electrical Code ANSI/NFPA 70, article 725 and the
Canadian Electrical Code part 1, section 16.
•
L'installation doit toujours être conforme aux dispositions applicables du
Code américain de l'électricité (National Electrical Code) ANSI/NFPA 70,
article 725, et du Code canadien de l'électricité.
RS-232
R
Tx Rx G
LAN
XMP 240 C AT
D
E
F
RS-232 Port
D
LAN Port
E
Reset Button and LED
F
External Power Supply
(12 VDC, 2.0 A max.)
XMP 240 C AT • Installation
5
Advertisement
Table of Contents
